If you wish to contribute or participate in the discussions about articles you are invited to join SKYbrary as a registered user
Start-up, Push-back and Taxi - A Guide for Controllers
From SKYbrary Wiki
Revision as of 16:15, 9 November 2012 by Editor1
This article is an element of the NATS Flight Deck Procedures - A Guide for Controllers
Start-up, Push-back and Taxi
To start and push back an aircraft, a ground crew (or start crew) is usually needed and is typically provided by the airport, and paid for by the airline.
Several accidents have occurred over the years during engine start and push-back and so good communication with the ground crew over the intercom is essential. Once the aircraft’s red flashing beacon is lit all non-essential ground crew must stay clear of the aircraft.
If the aircraft is at a gate it will require push back, which requires a tug. If parked on a stand it is often acceptable to taxi the aircraft directly from the stand.
ATC may provide a conditional clearance stating that pushback is approved once an aircraft passing behind has cleared. This must then be passed onto the ground-crew. The engines are usually started during the push-back. Traditionally engine start has been a critical element as it has resulted in problems, such as hot starts and hung starts. With modern engine control systems these problems are very rare however the crew still pay a lot of attention to the engine gauges during engine start, and look for indications of problems.
Once the engines are running and all after start checklists have been completed a taxi clearance will be obtained.
Prevention of Ground Collisions
Greater emphasis is now being given to the prevention of ground collisions and runway incursions. Procedures are therefore being adopted with the philosophy that both pilots are to monitor the taxi route and avoid being ‘heads down’ in the cockpit whilst taxiing. Common procedures that will be seen during the ground phase of the flight will therefore be:
- The ‘Before Taxi/After Engine Start’ checklist being completed before commencing taxi;
- The taxi route being confirmed between both pilots;
- Crews that are unfamiliar with the airfield may take a relatively long period of time to check the cleared taxi route on the aerodrome charts before commencing taxi;
- Turning points, holding points, runways and runway incursion hotspots being verbally called out.
In keeping with this philosophy it is therefore best practice for controllers to refrain from issuing any instructions when aircraft are approaching any such turning points or runways in order to avoid the pilots becoming distracted at those locations.
|Things to look out for|
Go To Take-off and Climb