If you wish to contribute or participate in the discussions about articles you are invited to join SKYbrary as a registered user


RJ1H, Zurich Switzerland, 2006

From SKYbrary Wiki

Revision as of 20:00, 15 October 2017 by Validator1 (talk | contribs)
On 26 January 2006, when fixed ground electrical power was connected to an Avro RJ100 which had just reached its destination parking gate at Zurich, a flash fire occurred which was visible in the flight deck and an emergency evacuation was ordered. As the air bridge was by this time attached to door 1L,the cabin crew deplaned the passengers that way and no slides were deployed. The Investigation concluded that the fire had been caused by contamination of the ground power connector with ramp de icing fluid and found that there has been similar previous events.
Event Details
When January 2006
Actual or Potential
Event Type
Category:Cabin Safety, Fire Smoke and Fumes, Ground Operations, Human Factors
Day/Night Day
Flight Conditions On Ground - Normal Visibility
Flight Details
Operator Swiss European Air Lines
Domicile Switzerland
Type of Flight Public Transport (Passenger)
Origin Hannover
Intended Destination Zürich Airport
Take off Commenced Yes
Flight Airborne Yes
Flight Completed No
Flight Phase Parked
Location - Airport
Airport Zürich Airport
Tag(s) Fire-Electrical origin,
De-Ice fluid contamination
Tag(s) Procedural non compliance
Tag(s) Emergency Evacuation
Tag(s) Flight Crew Evacuation Command
Damage or injury Yes
Aircraft damage Minor
Causal Factor Group(s)
Group(s) Aircraft Operation,
Airport Operation
Safety Recommendation(s)
Group(s) None Made
Investigation Type
Type Independent


On 26 January 2006, an Avro RJ100 being operated by Swiss European Airlines on a scheduled passenger service from Hanover to Zurich had reached the parking gate at destination in normal day visibility when a flash fire occurred following the connection of ground electrical power. The commander ordered an emergency evacuation but since the air bridge was already in position at the aircraft, the cabin crew decided to carry out a rapid disembarkation and all passengers and cabin crew were off the aircraft within two minutes. A flight deck fire extinguisher was used against the apparent origin of the fire, the vicinity of the First Officer’s rudder pedals.


An Investigation was carried out by the Swiss AAIB. It was found that the flight crew saw “an explosive flame, accompanied by extensive smoke” in the area of the First Officer’s rudder pedals”. It was noted that de-icing agents for movement areas are known to contain substances which represent potential hazards in terms of both corrosion and electrical short-circuits.

The Investigation found that ”on the basis of the chemico-physical analysis it can be assumed that the short-circuit was caused by airport manoeuvring area de-icing fluid which had penetrated the (aircraft ground electrical source) plug.” It was noted that a short-circuit in similar circumstances had previously occurred on 25 November 2005 when the ground power was switched on and that the internal investigation carried out at the time had come to the conclusion that airport surface de-icing agent had penetrated into the plug and caused the short-circuit. It was also noted that similar incidents had apparently also occurred at other airports in the region

It was noted that the First Officer had not correctly followed their prescribed duties following the evacuation order and in particular did not stop the APU. This had caused uncertainty amongst the cabin crew in respect of the order to perform an emergency evacuation. The cabin crew at the front of the cabin decided to initiate rapid disembarkation using the already-positioned air bridge and the rear cabin crew “acted only partially in accordance with the procedures specified by the airline for an emergency evacuation.”

The Investigation concluded the that Probable Cause of the event was:

“that the dock-side plug had been contaminated with de-icing fluid used for airport movement areas, causing a short circuit.

Various measures taken since during the course of the investigation were noted.

  • The Airport Operator suspended access to all fixed aircraft external power supplies until additional insulation measures had been taken.
  • The contracted Handling Agent issued a revised Safety Instruction in respect of the connection of fixed ground power to aircraft which included requirements to preclude the external power plug coming into contact with surface de icing fluid and to exclude ground staff from a “hazard area” defined as within 3 metres of the connection point.
  • Boeing and Airbus issued a joint letter in July 2006 in respect of “the negative effects of corrosion (from contact with airport surface de icing fluids) in the area of electrical systems and brakes.”

The Final Report was published on 16 February 2007 and may be seen in full at SKYbrary bookshelf: Investigation Report No. u1934

No Safety Recommendations were issued.

Further Reading