If you wish to contribute or participate in the discussions about articles you are invited to join SKYbrary as a registered user
Post Crash Fires
From SKYbrary Wiki
|Category:||Fire Smoke and Fumes|
POST IMPACT FIRE
In the event of an impact with the ground or an obstacle, which results in structural damage to an aircraft, a fuel and/or oil fed fire can start if fuel comes into contact with hot surfaces. Equally, if flammable material, being carried as dangerous goods on a Civil aircraft or as cargo by a military aircraft, is damaged or the containment compromised, it may ignite as a consequence of impact, contact with hot surfaces or, in the case of spillage of unstable chemicals, the atmosphere.
Fire can spread quickly to the fuselage and through the cabin generating heat, smoke, and toxic decomposition products. If the temperature of trapped smoke and gasses reaches the auto-ignition temperature, flashover will occur and an aircraft fuselage can be rapidly engulfed by flames.
Depending upon the severity of the crash, and any resulting fire, the effect on the aircraft can vary from minor damage to total hull loss. Similarly, the potential casualty consequence of a crash/fire event ranges from no injuries to the loss of life of all on board. Collateral damage and casualties are possible dependent upon the location of the crash.
For aircraft with a maximum certified take-off weight of 5700 kilograms or less, post-impact fire contributes significantly to injuries and fatalities in accidents that are otherwise potentially survivable.
- Aircraft Design. Aircraft structures and fuel systems can be designed to minimise the quantity of fuel spillage
- Fuel - Virtually all large passenger aircraft burn jet fuel and not AVGAS. The much higher flashpoint of jet fuel reduces the potential for a post crash fire.
- Preparation of the aircraft - where the crash landing is anticipated, for example if an off-field landing is necessary or the aircraft has a landing gear malfunction, then there are several things that can be done to reduce the probability and severity of a fire:
- Dump Fuel - if time and aircraft design allow, dump to reduce the amount of fuel and improve the handling of the aircraft. For aircraft not fitted with Fuel Dump capability, the aircraft can loiter in the vicinity of the landing airfield to burn gas. Note that, in the case of an onboard fire, smoke, or fumes, any delay to landing the aircraft, inclusive of dumping fuel, should not be considered.
- Isolate fuel systems - close crossfeed valves.
- Cabin - Prepare the cabin for emergency landing.
- Cargo - Jettison flammable cargo if possible and practical.
- Aircraft Evacuation - Expeditious emergency evacuation of the aircraft will minimise the loss of life in the event of a post crash fire. Consequently, robust training of the cabin crew in evacuation procedures is essential.
- Engine Shutdown & Aircraft Systems - To minimize the potential for injury during the evacuation, the flight deck crew will take all necessary actions to shut down and, using fire handles, condition levers, or fire push button (depending on aircraft type) isolate the aircraft engines. Depending upon the degree of damage to the aircraft, this may not always be possible.
- Rescue and Fire Fighting Services - Rescue and Fire Fighting Services (RFFS) are instrumental in saving lives and minimizing the damage from a post crash fire. If the crash occurs within the airfield boundaries, the initial RFFS response units will be on site within a very short period of time; often less than a minute. Response to an off airfield crash may take considerably longer due to the time it may take to locate the crash and to the accessibility of crash site.
Large amounts of fuel can be carried by modern aircraft and an aircraft crash has the potential to rupture the fuel tanks. Should the spilling fuel be exposed to a spark or open flame a fire may occur. This is particularly true of fuels with low flashpoints such as AVGAS. While jet fuels have a higher flashpoint and are less susceptible to sparks, exposing them to operating engines or to hot engine components may raise the temperature of the fuel to its auto-ignition point and a fire will result.
Accidents and Incidents
A selection of incidents from the SKYbrary database related to Post Crash Fire:
- PRM1, vicinity Samedan Switzerland, 2010 (On 19 December 2010, a Raytheon 390 inbound to Samedan from Zagreb made a daylight approach to runway 21 at destination in marginal VMC which involved a steep and unstable descent from which a landing was not possible. The subsequent go around was followed by entry to a visual right hand circuit which was contrary to local procedures due to terrain constraints. Overbanking in the turn towards final approach was followed by a stall and loss of control which led to ground impact which, with the post crash fire, destroyed the aeroplane and fatally injured both occupants.)
- SH36 / SH36, manoeuvring, Watertown WI USA, 2006 (On 5 February 2006, two Shorts SD-360-300 aircraft collided in mid air while in formation near Watertown, WI, USA; both aircraft suffered damage. One aircraft experienced loss of control and impacted terrain while the other made an emergency landing, overunning the runway, at a nearby airport.)
- GLF4, Bedford MA USA, 2014 (On 31 May 2014, a Gulfstream IV attempted to take off with the flight control gust locks engaged and, when unable to rotate, delayed initiating the inevitable rejected take off to a point where an overrun at high speed was inevitable. The aircraft was destroyed by a combination of impact forces and fire and all seven occupants died. The Investigation attributed the accident to the way the crew were found to have habitually operated but noted that type certification had been granted despite the aircraft not having met requirements which would have generated an earlier gust lock status warning.)
- GLF6, Roswell NM USA, 2011 (On 2 April 2011, the crew of a Gulfstream G650 undertaking a pre-type certification experimental test flight take off with one engine intentionally inoperative were unable to recover controlled flight after a wing drop occurred during take off. The aeroplane impacted the ground without becoming properly airborne and was destroyed by a combination of the impact and a post crash fire with fatal injuries to all four occupants. The subsequent Investigation found that preparation for the flight had been inadequate and had failed to incorporate effective response to previous similar incidents where recovery had been successful.)
- PRM1, vicinity Annemasse France, 2013 (On 4 March 2013, a Beechcraft Premier 1A stalled and crashed soon after take off from Annemasse. The Investigation concluded that the loss of control was attributable to taking off with frozen deposits on the wings which the professional pilot flying the privately-operated aircraft had either not been aware of or had considered insignificant. It was found that the aircraft had been parked outside overnight and that overnight conditions, particularly the presence of a substantial quantity of cold-soaked fuel, had been conducive to the formation of frost and that no airframe de/anti icing facilities had been available at Annemasse.)
- Safety issues investigation report SII A05-01 Post-impact fires resulting from small-aircraft accidents, TSB Canada, 2006
- CAP 699 - Framework for the competence of rescue and fire fighting service (RFFS) personnel, January 2017
- Aviation Accident Checklist, by ATSB, 7th edition, June 2017
- Hazards at Aviation Accident Sites - Guidance for Police and Emergency Personnel, by ATSB, 7th edition, June 2017