If you wish to contribute or participate in the discussions about articles you are invited to join SKYbrary as a registered user
|Tag(s)|| Weather Phenomena|
Mist and Fog
- 1 Description
- 2 Radiation Fog
- 3 Advection Fog
- 4 Frontal Fog and Hill Fog
- 5 Steam Fog
- 6 Effects
- 7 Airport operations in Fog
- 8 Solutions
- 9 Accident & Incident Reports Involving Operations in Fog
- 10 Airports near areas where Fog occurs
- 11 Further Reading
Mist and Fog are the terms used to describe low visibility caused by water droplets suspended in the air. Mist is a term used to describe visibility of greater than 1 km0.54 nm
3,280.84 ft while Fog is the term used when visibility is less than 1 km0.54 nm
Fog is effectively surface cloud and has a significant impact on the conduct of flying operations particularly landing and take-off.
There are many different types of fog defined according to how they are formed;
On a cloudless night, especially within a high pressure system, the land surface loses heat to the atmosphere by radiation and cools. Moist air in contact with cooling surface also cools and when the temperature falls below the dew point for that air, fog forms. This type of fog is known as radiation fog.
Formation of Radiation Fog
Initially it may be mist that forms and then thickens into fog as the temperature drops and more water vapour condenses into water droplets in the air. Air does not conduct heat very well so in still air conditions fog may not form at all and a layer of dew or frost will form on the surface instead. However, if there is a light wind of around 5 kts9.26 km/h
2.57 m/s, then this will mix the air in contact with the surface and the layer of fog will be thicker. With stronger winds, the fog may lift to form layers of Stratus
Dispersal of Radiation Fog
As the sun rises, and the surface temperature increases, the air in contact with the surface will warm and the fog will gradually disperse. The fog may rise to form a low layer of stratus.
If the fog is particularly thick, then it may prevent the sun from heating the surface and the fog will not clear. This situation is common in the autumn in northern Europe when some airfields may be affected by fog for many days.
Anticipating Radiation Fog
The three conditions required for radiation fog are:
- clear skies,
- moist air, and
- a light wind.
Advection fog occurs when a warm, moist, air mass flows across a colder surface. The air mass is cooled from below by the colder surface and, if the temperature of the air mass is reduced to the dew point, then fog forms.
Formation of Advection Fog
Advection Fog is a regular springtime occurrence in coastal areas of north western Europe when relatively warm moist air moves towards land from offshore - the North Atlantic and waters around the British Isles - over colder land and shallow water surfaces.
Advection Fog can also occur over deep sea areas when warm maritime air passes over colder water such as that found in water flowing south from Arctic waters or where cold water wells up from the deep ocean.
In the Arctic, particularly in northern Canada, where there are wide expanses of water and numerous islands with small airstrips, advection fog is a significant impediment to aviation. Visibility can change from unlimited to zero in a very short space of time because just a slight change in wind direction can increase the relative humidity of air over the sea by increasing the fetch or sea distance travelled prior to it reaching a colder landmass. This type of fog can clear and the visibility can improve just as rapidly as it declined and such conditions can be difficult to forecast reliably.
It should be noted that unlike radiation fog, advection fog can be accompanied by winds of any strength up to gale force.
Frontal Fog and Hill Fog
Frontal fog occurs in two ways:
- When, during the passage of a front, cloud extends down to the surface. This is especially the case over higher ground and may also be termed Hill Fog.
- When the air in contact with the surface becomes saturated by evaporation from the rain that has fallen. These conditions may occur in the cold air ahead of a warm front.
Steam Fog occurs when very cold air flows across relatively warm water. Water vapour evaporating from the surface of the water rapidly cools below its dew point, as it is mixed with and cooled by the cold air, and condenses to form fog.
Formation of Steam Fog
Steam Fog, also known as Steaming Fog, Evaporation Fog, Frost Smoke or Arctic Sea Smoke, occurs when evaporation takes place into cold air lying over warmer water. It is usually quite shallow. This phenomenon is mainly a feature of higher latitudes especially in winter.
It is named by analogy with the condensed vapour or steam which appears above water which is heated. Invisible vapour is given off from the water but is almost immediately recondensed as it comes into contact with the colder air. The air has to be much colder than the water so that convection currents develop. Formation also requires that there is:
- A marked surface temperature inversion in the air before it moves over the sea or inland water bodies so as to preclude the lapse rate becoming unstable through a deep layer
- A low air temperature, typically 0°C273.15 K
491.67 °R or below, so that a comparatively small amount of moisture can produce supersaturation, otherwise the heating process will outweigh the tendency towards saturation.
Because of these requirements, this type of fog is usually only formed over water surfaces near to a source of cold air, such as frozen ground or ice sheets in polar regions. One classic occurrence is following the sudden break up of sea ice to expose relatively warm water.
In the steep sided fjords along parts of the Icelandic and Norwegian Coasts and similar environments elsewhere, steam fog may reach a depth of 500 feet or more and drift over adjacent land areas. Whilst relatively rare in temperate latitudes, cold air which collects in and then drifts down large river valleys and out over a relatively warm sea surface, in very light wind conditions, can occasionally lead to the formation of smaller and much shallower areas of this type of fog in winter.
In a more ephemeral context but by exactly the same process, many people will have seen the steaming of tarred road surfaces or bitumen roofs in sunshine after rain.
- Low visibility. Low visibility in fog clearly affects flying operations.
Airport operations in Fog
Reduced visibility because of fog may result in restrictions on both ground and airborne movements at an airport and both can have the effect of reducing capacity because of the safety-predicated consequences of Low Visibility Operations(LVO). Nowadays, with many more aircraft being able to land and take off in very low surface visibility, the ultimate capacity constraint can sometimes be maintaining the safety of aircraft ground movement.
- When conditions for radiation fog exist, it is a good idea to examine the pattern of weather over the preceding days to see if fog has occurred and at what time of the day and at what temperature.
- Monitoring the temperature and dewpoint at an airport can help controllers and pilots alike to predict the onset of radiation fog and plan operations accordingly.
- If conducting local flying operations, such as flying training, beware getting airborne when there is early afternoon lifting of fog while conditions for radiation fog still exist - you could find yourself spending the night somewhere else!
- If planning to fly to an aerodrome where conditions for radiation fog exist,
- time your planned arrival for about an hour after local noon when maximum solar heating takes place.
- expect delays and carry additional contingency fuel.
- Flying at low level, i.e. below safety altitude, in conditions of frontal fog and low cloud can quickly become extremely hazardous if visual flight rules cannot be maintained. Attempting to fly between layers of Stratus, so-called "letter boxing", can result in impact with terrain CFIT if forward visibility and Situational Awareness is lost.
- In circumstances where advection fog can quickly make an aerodrome unusable, the same risk may apply to potential diversions as well and pilots should ensure that an appropriate fuel endurance is available and that alternates unlikely to be affected by advection fog remain within range in the event that the destination weather deteriorates unexpectedly.
Information on improved forecasts of clearing time of advection fog over the approaches to San Francisco International Airport is available at the following the case-study article: Forecast-base decision support for San Francisco International airport, NextGen Prototype System That Improves Operations during Summer Stratus Season (David W. Reynolds, David A. Clark, F. Wesley Wilson, and Lara Cook)
- Crews and controllers should exercise additional caution during low visibility operations - loss of situational awareness is a major contributory factor in Runway Incursion events.
- Airports should ensure that collaborative decision making arrangements to maximise airport capacity involve met service providers.
- Flight crews should anticipate longer taxiing times in low visibility operations and carry additional fuel accordingly.
Accident & Incident Reports Involving Operations in Fog
- B738, Mangalore India, 2012 (On 14 August 2012, a Boeing 737-800 crew continued a previously stable ILS Cat 1 approach below the prescribed MDA without having acquired the prescribed visual reference. The aircraft was then damaged by a high rate of descent at the initial touchdown in the undershoot in fog. The occurrence was not reported by either the crew or the attending licensed engineer who discovered consequent damage to the aircraft. Dense fog had prevented ATC visual awareness. The Investigation attributed the undershoot to violation of minima and to both pilots looking out for visual reference leaving the flight instruments unmonitored.)
- DC93 / B722, Madrid Spain, 1983 (On 7 December 1983, a Boeing 727-200 taking off from Madrid in thick fog collided at high speed with a Douglas DC-9 which had not followed its departure taxi clearance to the beginning of the same runway. The DC-9 crew did not advise ATC of their uncertain location until asked for their position after non-receipt of an expected position report. The Investigation concluded that flight deck coordination on the DC-9 had been deficient and noted that gross error checks using the aircraft compasses had not been conducted. The airport was without any surface movement radar.)
- A320, Jaipur India, 2014 (On 5 January 2014, an Airbus A320 was unable to land at Delhi due to visibility below crew minima and during subsequent diversion to Jaipur, visibility there began to deteriorate rapidly. A Cat I ILS approach was continued below minima without any visual reference because there were no other alternates within the then-prevailing fuel endurance. The landing which followed was made in almost zero visibility and the aircraft sustained substantial damage after touching down to the left of the runway. The Investigation found that the other possible alternate on departure from Delhi had materially better weather but had been ignored.)
- C500, vicinity Santiago Spain, 2012 (On 2 August 2012, a Cessna 500 positioning back to base after completing an emergency medical team transfer operation earlier in the night crashed one mile short of the runway at Santiago in landing configuration after being cleared to make an ILS approach. The Investigation concluded that the approach was unstabilised, had been flown without following the ILS GS and that the crew had used DME distance from the VOR near the crash position rather than the ILS DME. Fog was present in and around the airport.)
- S61, vicinity Bødo Norway, 2008 (On 24 February 2008, a Sikorsky S-61N being operated by British International Helicopters on a passenger flight from Værøy to Bødo attempted a visual approach at destination in day IMC and came close to unseen terrain before accepting an offer of assistance from ATC to achieve an ILS approach to runway 07 without further event. None of the 18 occupants were injured.)
Airports near areas where Fog occurs
- Abbotsford International Airport
- Abu Dhabi International Airport
- Actau Airport (formerly Shevchenko-Central)
- Adak Airport
- Algiers/Houari Boumediene Airport
- Almaty International Airport
- Arcata Airport
- Atyrau Airport
- Chongqing Jiangbei International
- Churchill Airport
- Del Norte County Airport
- Kassel-Calden Airport
- Kerry Airport
- Krakow International Airport
- Kuwait International
- LA/Ontario Airport
- Marine Corps Air Station Miramar
- Minneapolis-Saint Paul International Airport
- Monterey Regional Airport
- Naval Air Station North Island
- North Bay Jack Garland Airport
- Nuremberg Airport
- Oakland International Airport
- Pond Inlet Airport
- RAF Benson
- Riyadh/King Khaled International Airport
- Rothera Research Station
- San Diego International Airport
- San Francisco
- Shymkent Airport
- St. Paul Downtown Airport
- Tarbes-Lourdes-Pyrénées Airport
- Tenerife Norte/Los Rodeos
- Unalaska Airport
- Vancouver International Airport
- Verona Airport
- William R. Fairchild International Airport
- Freezing Fog
- Ice Fog
- Low Visibility Procedures
- ICAO Doc 013 European Guidance Material On All Weather Aerodrome Operations, 4th Edition, 2012
- ICAO Doc 9365 Manual of All-Weather Operations, 3rd Edition, 2013