If you wish to contribute or participate in the discussions about articles you are invited to join SKYbrary as a registered user
A310, Vienna Austria, 2000 (LOC HF AW)
From SKYbrary Wiki
|On 12 July 2000, an Airbus A310 being operated by Hapag Lloyd on a non scheduled passenger flight from Chania to Hannover declared an emergency due to fuel shortage and, after making an en route diversion to Vienna in day VMC, crash landed short of runway 34.|
|Event Type||AW, HF, LOC|
|Type of Flight||Public Transport (Passenger)|
|Actual Destination||Vienna International/Schwechat|
|ENR / APR|
|Location - Airport|
|Tag(s)|| Inadequate Airworthiness Procedures|
Inadequate Aircraft Operator Procedures
|Tag(s)|| Ineffective Monitoring|
Data use error
Procedural non compliance
Inappropriate crew response (technical fault)
|Tag(s)|| Loss of Engine Power|
Flight Management Error
Delay in Declaration of Emergency
|Contributor(s)|| Maintenance Error (valid guidance available)|
Component Fault in service
|Damage or injury||Yes|
|Aircraft damage||Hull loss|
|Causal Factor Group(s)|
|Group(s)|| Aircraft Operation|
|Group(s)|| Aircraft Operation|
On 12 July 2000, an Airbus A310 being operated by Hapag Lloyd on a non scheduled passenger flight from Chania to Hannover declared an emergency due to fuel shortage and, after making an en route diversion to Vienna in day VMC, crash landed short of runway 34. None of the 151 occupants were injured during the impact but 26 suffered minor injuries during the subsequent evacuation. The aircraft was damaged beyond economic repair by the effects of the impact but there was no fire.
It was established that the first ground impact had occurred some 660 m prior to the runway threshold, slightly the right of the extended centerline and thereby avoiding the runway lighting masts. The left main landing gear collapsed soon afterwards and the aircraft had continued to skid through a series of minor aerial and lighting obstructions before finally coming to a stop close to the southernmost taxiway to the runway.
Fuel on board after the crash did not leak away and was found to be equivalent to the design specification for ‘unusable fuel’.
It was established that after take off from Chania with the Captain as PF, the crew had received indications that landing gear retraction had not been successful. The required ECAM actions and consultation with related ‘abnormal and emergency procedures’ followed but gear locked up could not be achieved and it had been decided that as a reduced rate of climb was not going to be a problem for the climb, the flight would continue towards the destination with the gear down and subject to monitoring of fuel use. It was recognised that the intended destination could not now be reached and various alternatives – Stuttgart (STG), Munich (MUC) and eventually Vienna (VIE) were considered in conjunction with the Company Operations Centre. Vienna ultimately became the planned diversion.
It was noted that an hour before the crash, a calculation of the expected residual fuel by the First Officer showed that it was below 1900kg, the level at which operator procedures made a diversion to the nearest suitable aerodrome. At this juncture, it would have been possible to reach Zagreb (ZAG) in 10 minutes but this was not considered. Nine minutes later, the planned diversion to Vienna was confirmed and a series of requests for direct routing began to be made to ATC. Ten minutes later, whilst still under the control of Zagreb ACC, Vienna ACC ATC were advised on box 2 that unless a direct approach could be given, the flight would need to divert to Graz, but no indication of any actual risk was communicated. The request was granted and the flight continued towards Vienna. After a further 8 minutes, the “LT-Fuel low level” warning light came on 131 nm242,612 m
795,971.129 ft from Vienna and six minutes after that, after earlier proposals from the First Officer to do so had been ‘deferred’ by the Captain, an emergency was declared.
Some 11 minutes prior to the eventual crash landing, it was noted that both crew members had assessed the situation as “unpromising”. Visual contact with Vienna was acquired and a visual approach to runway 34 was approved by ATC. At 11:26, both engines failed due to fuel exhaustion some 12 nm22,224 m
72,913.386 ft from Vienna with the aircraft intentionally positioned above the ILS GS profile. The crash landing occurred 8 minutes later, at 11:34.
The analysis made by the investigators particularly focused on the incomplete awareness of the flight crew on procedures for continuation of the flight with the gear down including the use of the FMS for monitoring of fuel used / remaining and on the series of decisions which led to the attempt to reach Vienna despite a progressive recognition that the fuel on board was unlikely to make this option a safe prospect.
The aircraft commander was found to have been very experienced, the First Officer was relatively new to professional flying and had obtained his A310 type rating a little over 7 months prior to the accident. The training records of both were found to be exemplary.
The organisational, physiological and psychological precursors to what happened were examined in some detail. It was suggested that “Insufficient knowledge of the basic method of operation and performance limitations of the FMS in certain situations because of a lack of documentation and training caused the pilot to incorrectly evaluate flight parameters and resulted in incorrect decisions concerning the piloting of the aircraft” and also that “Restricting the simulator training to landing gear problems on domestic flights helped produce negative training effects. On the one hand, the unilateral training scenario resulted in methodism, i.e. the creation of a standard plan to deal with the task”.
Overall, it was concluded that “The captain's decision to continue the flight to VIE rather than, as provided for in the airline's regulations, to proceed to the nearest aerodrome (which at that point was ZAG), is explained by the phenomenon called ‘pressing on’. It is often found in air accident situations, and is determined by the joint effects of the emotion components (motivation to succeed or defence against fear) and the cognitive structuring of tasks”.
The investigation also proposed that an additional reason for ‘pressing on’ to VIE was the Captain’s preference for personal ‘success’ - achieving a diversion to VIE - rather than ‘failure’ which would not have been matched by a successful diversion to ZAG. It was concluded that “the captain's decision (to continue to VIE) was based on a consideration not of the safety risks but of the likelihood of success and failure”. It was also proposed that “because of the intensive mental effort required for the landing at VIE, achieving this scenario (became) subjectively more probable than a scenario which (had) not been so carefully thought through”.
In respect of the landing gear retraction problem which had initiated the sequence of events, it was found that a wash locker had not been screwed into place in the right-hand landing gear actuation cylinder and had worked loose. The extended working length had then prevented the landing gear leg from retracting.
Cause & Contributory Factors
The Cause of the accident was formally recorded as:
“Continuation of a flight with a landing gear problem until the engines failed because of a lack of fuel”
and Contributory Factors as:
- No or inadequate preventive measures by the manufacturer, certification authority and airline regarding previous publications of ICAO and the EU's DG VII relating to problems which had arisen and had been recorded following the introduction of aircraft equipped with advanced technology.
- Anthropotechnical design shortcomings increasing the likelihood of misinterpretation of the FMS EFOB display.
A total of 14 Safety Recommendations were made as follows:
- Although the procedure for the assembly of the actuation cylinder is described in detail in the Component Maintenance Manual (CMM), these instructions should contain a reference to the correct engagement of the wash locker in the rod end.
- Improve the FMS EFOB or ECAM displays in order to take better account of the anthropotechnical requirements.
- Provide the requisite fuel tables and/or calculation algorithms for the entire area of deployment (computer programs).
- Clarify and improve the transparency of Chapter 21 as regards flights with landing gear extended, in order to avoid contradictions and misinterpretations.
- Check the deployment of the emergency slides as regards wind tolerance and unusual aircraft positions.
To Hapag Lloyd
- Expand the LOFT to include fuel scenarios which take account of the operational limits of the FMS and require strategic decisions by the flight crew using other calculation methods in order to avoid the manifestation of methodisms.
- Implement the assistance for the flight crew by the flight dispatcher provided for in Annex 6 and in the Quality Manual.
- Add the bullet point published by the manufacturer "fuel consumption determine" to the "landing gear unsafe indication" checklist.
- Continuously check the completeness of onboard documentation as regards the available approach procedures.
- Train operational staff using the Human Factors Limitation Curriculum recommended by ICAO in its Human Factors Digest No 3 (35-hour course).
- Improve CRM training as regards assertiveness, communication, acceptance, criticism, feedback, and the indicators of loss of situational awareness and counterstrategies.
- Demonstrate the limitations of the FORDEC principle (e.g. in the event of a masking effect where facts are being ascertained).
- Take account of abnormal aircraft configurations when calculating the final reserve.
Jointly to Hapag Lloyd and Airbus
- Improve documentation and training relating to the functioning and operational limitations of the FMS.
The Final Report of the Investigation was issued on 21 March 2006 in the German language only. This summary is based upon a reliable but unofficial translation into the English language.
- Press-on-itis (OGHFA BN)
- Unexpected Events Training (OGHFA BN)
- Decision-Making (OGHFA BN)
- Decision-Making Training (OGHFA BN)
- CRM Skills Training (OGHFA BN)
- Decision Making
- Line Oriented Flight Training
- Landing Gear Problems: Guidance for Controllers
- Landing Gear Problems: Guidance for Flight Crews
- Abnormal Aircraft Configuration and FMS Fuel Predictions
- Situational Awareness